Snap a chalk line to identify the underlying trusses and nail the sheeting in place with 8d nails every 8 inches. This tutorial is designed to walk you through the steps of building a shed roof for a simple gable roofed shed for spans up to 10′. Make sure the trusses are equally spaced, leaving about 24” on canter between them. Install the roof sheeting: Begin installing the roof sheeting with a full 8 ft sheet aligned at the top edge of the truss and put a single nail in the outside corner at the top of the truss. Add fascia on the end of the rafters and a perforated soffit on the underside of the rafter between the fascia and the exterior wall. Cut them with a jigsaw. This is your angle for your front cut. Nail or tack the paper down lightly. With the barn style shed, I will nail one truss end down then move to the other end and nail it down before nailing on my next truss.
A New Analysis On Strategies For How To Build A Shed Roof
The rafters must be longer than the buildingâ€™s size, overhanging at each end of the house. It is good to wait until this point to build the side walls. Now make sure the outside truss is flush with the edge of your ob sheet and nail into place every 6 inches. Many brands of O.S.B. have markings that are close to the 24 inch on canter layout to help you locate the rafters below. Start at the bottom edge and work your way up the roof. Secure the shingles with roofing tacks. Photo 13: Mark the angled cuts on the side trim pieces Mark and cut the side trim pieces. Assemble the gable roof.